洪泽湖水体富营养化时空分布特征与影响因素分析

通过2014年—2017年对洪泽湖12个水质断面定期调查,采用营养状态指数(TLI)综合评价其水体富营养状态,同时应用主成分分析方法(PCA)分析其富营养化状态的时空变化特征。结果表明,洪泽湖70%以上的调查断面水质全年处于轻度富营养化状态,夏季是其富营养化最严重的季节;洪泽湖年内水体水质差异较大,而其水华特征并未呈现明显差异;洪泽湖富营养化很大程度上受制于营养盐的积累程度,并与湖泊透明度呈现极显著的负相关关系(p0.001),与湖水pH值呈现极显著的正相关关系。     

太原汾河景区跨桥断面水体污染的时空变化模式研究

选取太原汾河景区跨桥断面8个监测点,在2012年3月—2013年10月期间对河流8项水质参数进行监测,并结合派生的水体综合污染指数及主成分分析方法分析和评价景区水污染时空变化特征。结果表明,景区水质污染变化时空差异明显,上游污染相对较小,下游污染较重;春季溶解氧和p H值变化幅度最大,夏季除总氮和氨氮外,其他各污染物均有显著变化特征,秋季则以氨氮、总氮和总磷变化最为显著。主成分分析结果显示,虽然各监测点水体污染的关键影响因子不同,但总磷是太原市河流水体污染的共同解释因子。     

Challenges for modelling and integrating environmental performances in concept design: the case of an automotive component lightweighting

The objective of this paper is to discuss the main barriers for modelling and integrating the environmental performances in the automotive concept design. Incorporating environmental assessment in the early design phase of a vehicle component is known as an important challenge that car makers need to face in order to develop more sustainable design solutions; in this regard, the Life Cycle Assessment is the most widespread methodology for the environmental assessment and comparison of alternatives. The present work illustrates the combination of such methodology with the traditional design procedure at two different levels of the component design phase, material choice and concept design. In particular, the potential benefits originated by a lightweight solution for the automotive component Throttle Body are evaluated by considering environmental and technical implications at the same level. The case study shows that a multi-disciplinary approach for design effectively allows the integration of the environmental issue in the company’s established procedures. However, interpretation of results is still a challenging aspect due to the inevitable contradicting elements which should not discourage to develop comprehensive sustainability assessment within the early design stage.     

The Use of Natural Taraxacum officinale Wigg. Populations for Assessing the State of Technogenically Disturbed Areas

Russian Journal of Ecology -     

Evaluation of the temporal variations of air quality in Taipei City, Taiwan, from 1994 to 2003

Data collected from the five air-quality monitoring stations established by the Taiwan Environmental Protection Administration in Taipei City from 1994 to 2003 are analyzed to assess the temporal variations of air quality. Principal component analysis (PCA) is adopted to convert the original measuring pollutants into fewer independent components through linear combinations while still retaining the majority of the variance of the original data set. Two principal components (PCs) are retained together explaining 82.73% of the total variance. PC1, which represents primary pollutants such as CO, NO(x), and SO(2), shows an obvious decrease over the last 10 years. PC2, which represents secondary pollutants such as ozone, displays a yearly increase over the time period when a reduction of primary pollutants is obvious. In order to track down the control measures put forth by the authorities, 47 days of high PM(10) concentrations caused by transboundary transport have been eliminated in analyzing the long-term trend of PM(10) in Taipei City. The temporal variations over the past 10 years show that the moderate peak in O(3) demonstrates a significant upward trend even when the local primary pollutants have been well under control. Monthly variations of PC scores demonstrate that primary pollution is significant from January to April, while ozone increases from April to August. The results of the yearly variations of PC scores show that PM(10) has gradually shifted from a strong correlation with PC1 during the early years to become more related to PC2 in recent years. This implies that after a reduction of primary pollutants, the proportion of secondary aerosols in PM(10) may increase. Thus, reducing the precursor concentrations of secondary aerosols will be an effective way to lower PM(10) concentrations.     

Characterization and Identification of the Sources of Chromium, Zinc, Lead, Cadmium, Nickel, Manganese and Iron in Pm10 Particulates at the Two Sites of Kolkata, India

Monitoring of ambient PM₁₀ (particulate matter which passes through a size selective impactor inlet with a 50% efficiency cut-off at 10 μm aerodynamic diameter) has been done at residential (Kasba) and industrial (Cossipore) sites of an urban region of Kolkata during November 2003 to November 2004. These sites were selected depending on the dominant anthropogenic activities. Metal constituents of atmospheric PM₁₀ deposited on glass fibre filter paper were estimated using Inductively Coupled Plasma Atomic Emission Spectrometer (ICP-AES). Chromium (Cr), zinc (Zn), lead (Pb), cadmium (Cd), nickel (Ni), manganese (Mn) and iron (Fe) are the seven toxic trace metals quantified from the measured PM₁₀ concentrations. The 24 h average concentrations of Cr, Zn, Pb, Cd, Ni, Mn and Fe from ninety PM₁₀ particulate samples of Kolkata were found to be 6.9, 506.1, 79.1, 3.3, 7.4, 2.4 and 103.6 ng/m³, respectively. The 24 h average PM₁₀ concentration exceeded national ambient air quality standard (NAAQS) as specified by central pollution control board, India at both residential (Kasba) and industrial (Cossipore) areas with mean concentration of 140.1 and 196.6 μg/m³, respectively. A simultaneous meteorology study was performed to assess the influence of air masses by wind speed, wind direction, rainfall, relative humidity and temperature. The measured toxic trace metals generally showed inverse relationship with wind speed, relative humidity and temperature. Factor analysis, a receptor modeling technique has been used for identification of the possible sources contributing to the PM₁₀. Varimax rotated factor analysis identified four possible sources of measured trace metals comprising solid waste dumping, vehicular traffic with the influence of road dust, road dust and soil dust at residential site (Kasba), while vehicular traffic with the influence of soil dust, road dust, galvanizing and electroplating industry, and tanning industry at industrial site (Cossipore).     

微生物絮凝剂PF-2的成分分析及絮凝机制研究

筛选得到的荧光假单胞菌(Pseudomonas fluorescens)产生的絮凝剂——PF-2在处理高岭土悬浊液时,具有用量少、絮凝效果好等优点,对高岭土悬浊液的絮凝率可达96.5%.呈色反应和紫外扫描的测定结果表明,PF-2大部分为胞外分泌的多糖,含有少量的核酸,提取后每升发酵液可制得絮凝剂粗品2.3 g;ζ电位测定及氢键和离子键检验结果表明,PF-2与高岭土颗粒之间的作用力为离子键;红外光谱扫描分析PF-2中含有O-H、C-H、C＝C和C-O-C等多糖的特征吸收峰;利用扫描电镜观察絮体形态表明,絮体结构密实,其絮凝机制为PF-2和高岭土以离子键的形式结合,之后通过架桥作用絮凝沉淀.     

铅锌矿区玉米中重金属污染特征及健康风险评价

以西南某铅锌矿区为研究区域,测定了92份玉米样品中Pb、Zn、Cd、Cr和Ni的含量,开展了矿区玉米籽粒中重金属污染特征及健康风险研究.应用单因子污染指数和内梅罗综合污染指数分析了重金属在玉米中的污染状况,采用健康风险评价模型评价了重金属对人体健康造成的风险,同时利用主成分分析法解析了重金属的主要来源.结果表明,玉米籽粒中Pb、Zn、Cd、Cr和Ni的平均含量分别为0.30、23.75、0.21、1.33和1.15 mg ·kg^-1;除重金属Zn外,其他4种重金属均超过我国食品卫生标准限值,研究区玉米籽粒中Pb、Cd、Cr和Ni的综合污染指数范围介于4.32~9.07之间,均属于重度污染,Zn的综合污染指数小于1;重金属通过玉米籽粒摄入引起的复合重金属污染对成人和儿童均存在健康风险,且对儿童造成的健康风险高于成人.玉米籽粒中5种重金属可以由2个主成分来反映,第一主成分主要支配Pb、Cd、Cr和Ni的来源,第二主成分支配Zn的来源.玉米籽粒重金属含量与土壤重金属含量之间没有明显相关性.     

基于绝对主成分-多元线性回归的滇池污染源解析

定量解析污染源是湖泊流域水环境管理的重要基础.基于滇池草海和外海多年水质监测数据,采用主成分分析（PCA）方法识别了主要水质指标的污染源类型,利用绝对主成分-多元线性回归模型（APCS-MLR）得到不同污染源对水质的贡献程度.结果表明,草海主要的污染源有农业面源、城市面源和内源3类,外海的主要污染源是农业面源、城镇生活污染源、城市面源和内源4类.与河流水污染源解析结果不同,底泥内源与气象因子对滇池主要水质指标的影响较大.     

焚烧飞灰重金属含量及浸出长期变化规律研究

通过对24个飞灰样品的重金属全量消解和高精度X射线荧光光谱法（HDXRF）快速检测结果进行线性回归分析,发现HDXRF法可较准确测定飞灰中Cu、Pb、Zn、Ni和Cd含量（线性回归决定系数R²³0.90）.采用HDXRF法对某焚烧厂飞灰重金属含量6个月快速检测及浸出毒性测定数据统计分析发现：飞灰重金属月均含量较稳定（变异系数CV<0.14）但日均含量波动较大（CV>2.54）;飞灰中Pb、Cu和Zn含量呈正相关（相关系数r>0.78）;金属浸出浓度受浸出液终点pH值影响显著,超标频率依次为Pb（68.9%）、Cd（66.1%）、Ni（24.0%）、Cu（14.2%）和Zn（1.6%）.短期飞灰金属含量和浸出毒性数据受焚烧工况,烟气处理工况和垃圾组分等多种因素共同影响,不具有代表性.为评估垃圾分类源头削减重金属效果,建议采用快速检测方法对焚烧飞灰重金属含量进行长期监测.